Molds for thin-wall flower pots and planters
Sizes from 90 mm to 200 mm pot diameter, hot runner, samples in the album.
Molds for thin-wall flower pots, from small 90 mm pots up to 200 mm planters. The tapered wall means the part is ejected by air assist, and the bottom is cooled through a separate circuit so the pot does not sink at the base.
| Cavity | 1 – 8, stack moulds with higher cavitation on request |
|---|---|
| Mold steel | S136 / H13 / STAVAX / 1.2083 / 1.2344 / 4Cr13 / 2316 / SKD61 / P20 |
| Core & cavity | Vacuum hardened, single-cavity inserts for easy replacement |
| Cooling system | Optimised water circuit — faster cycles, lower moulding cost |
| Runner | Hot runner system |
| Design software | UG / AutoCAD |
| Surface treatment | Full-mould plating |
| Mold life | ≥ 3,000,000 shots under normal use |
During production we send regular progress reports and photos of the mold as agreed, so you can follow every stage from design approval to trial run and shipment.