Home » Products » Injection Moulds » cap molds » Water Bottle Cap Mold

Products

Water Bottle Cap Mold

Water Bottle Cap Mold

Hot-runner mold for 28 mm water bottle caps

Balanced hot-runner layout with optimised cooling for high-speed production of carbonated and still water caps.

Categorycap molds

A high-cavitation mold built for bottled-water lines, where cycle time decides the cost per cap. The hot-runner layout is balanced so every cavity fills at the same pressure, and the conformal cooling circuit pulls heat out of the thin cap wall evenly to keep ovality and thread dimensions inside tolerance.

  • Balanced hot-runner manifold for uniform filling
  • Hardened inserts — replace a single cavity instead of the whole plate
  • Optimised cooling for short cycles on thin walls

Mold specifications

Cavity1 – 72, customised to your injection press
Mold steelS136 / H13 / STAVAX / 1.2083 / 1.2344 / 4Cr13 / 2316 / SKD61 / P20
Core & cavityVacuum hardened, single-cavity inserts for easy replacement
Cooling systemOptimised water circuit — faster cycles, lower moulding cost
RunnerHot runner system
Design softwareUG / AutoCAD
Surface treatmentFull-mould plating
Mold life≥ 3,000,000 shots under normal use

Project follow-up

During production we send regular progress reports and photos of the mold as agreed, so you can follow every stage from design approval to trial run and shipment.

Related Products